Compression molding is a manufacturing process that uses a cavity half and a core half of a mold to form material into a specific shape created by the two mold halves. Compression molds vary depending on the material being compressed and the dictates of the type of mold required.
Typically, a compression mold is mounted in a vertical press (unlike the horizontal presses that are prevalent in the Injection Molding process). Compression molding often requires that the [charge" of material be loaded into the mold, either manually or automatically, prior to the mold halves closing.
we ever did many compression silicon parts , the hardness from 30shore A till 80shore A, colors can be customized whatever you want, we can do the compound color for you. Several free samples for the review before the overall demand running to ensure everything is clear and aligned to go. Please contact us for the professional suggestions, we have been in this field for more than 15years. thanks.
Compression Molding,Compression Forming,Rubber Compression Molding,Compression Moulding Process Suzhou FCE precision electronics Co., LTD , https://www.fukeyifcesz.com
1. You must not go to the car wash shop or ask others to help with the car wash. It is as if your own wife cannot let others shower him. The car wash shop looks like a complete set of operating rules, but the problems with poor efficiency are also present. It is not good to make a fire plug and various lines out of trouble.
2, be sure to cool the hot car and wash. Suddenly using cold water to flush the engine, exhaust pipe and other components, the principle of thermal expansion and contraction are clear to everyone, will destroy the various parts of the oil seal, resulting in engine oil leakage, a lot of motor-friendly engine oil is a slight reason for this. It will also cause rust and rust on the rhodium plated layer at the connection between the exhaust pipe and the engine.
3, headlights, left and right handrails, electric doors, exhaust pipe exhaust (preferably use things to plug), horns, cremation plugs, air filters, batteries and other parts is best not to wash directly with water, these parts have circuits, When it gets wet, it will cause a short circuit or leakage, and the lamp will not turn on, the speaker will not ring, the fire will not go off, and the driving will fail. It is best to scrub with a rag.
4, the car must be the lower part of the engine and the heat sink to clean, it is recommended to use a toothbrush dip detergent wash, this benefit is not only beautiful, but also can easily find engine oil leakage and other issues.
5, after the car wash, the whole car should be dry with a dry rag, especially the switch, instrument, left and right handrails, cremation plugs, fuel tank caps and other parts, pay special attention to the fire plug cap thrown down a few times, the upper casing Water throws out, otherwise it will affect the ignition.
6. After the vehicle is dry, start the vehicle. The stand frame stands idle for 5-10 minutes, exhaust the water in the exhaust pipe, and then drive on the medium speed for a few minutes or dry in the shade. Do not expose it to the sun.
7, the car after cleaning the shell can be sprayed with wax, with a fine emery cloth to wipe evenly, the chain should be re-lubricated again.
8. Each time it rains and bikes to go home, the car is put into storage. Pay attention to dry the car, especially the exhaust pipe. Now the pollution is serious, the rainwater is acidic, and the exhaust pipe is bad for most reasons. Although it is troublesome, it is absolutely a car-loving way.
Car washing is one of the essential basic skills of the majority of friends. Some seniors have already expressed their opinions on the forum.