Zinc stearate is a white powder, insoluble in water.It is mainly used as lubricant and release agent of styrene resin, phenolic resin and amine resin.At the same time in the rubber also has vulcanization active agent, softener function.
It is mainly used as lubricant and release agent of styrene resin, phenolic resin and amine resin.At the same time in the rubber also has vulcanization active agent, softener function.For example, it can be used as a heat stabilizer for PVC resin.For general industrial transparent products;With calcium soap, can be used for non-toxic products, general this product is used for soft products, but in recent years have begun to use hard transparent products such as mineral water bottles, water pipes and other products, this product lubricity is good, can improve the phenomenon of fouling precipitation, but also as a lubricant, release agent, and paint smooth agent, coating additives.
Stearic acid zinc salt,Zinc Stearate Powder,stearic acid,stearic acid amide,hemical zinc stearate powder Guangzhou Quanxu Technology Co Ltd , https://www.skysilmattingagent.com
1. The influence of three elements: In the cutting process of the radial drilling machine, generally want to obtain shorter treatment time, long-term expectation and high-precision tool life. Therefore, it is necessary to fully consider the raw material, hardness, shape of the workpiece material, and the machine function, select suitable tools and apply high-efficiency cutting conditions.
2, the impact of cutting speed: cutting speed has a very big impact on tool life. The progress of cutting speed is fast and the cutting temperature rises, leaving several shortened tool life. Disposal is not the same species, the hardness of the workpiece, the cutting speed will change accordingly. A lot of cutting tests have resulted in:
1) In general, the cutting speed is increased by 20%, the tool resistance cost is decreased by 1/2, the cutting speed is increased by 50%, and the tool resistance cost is reduced to 1/5 of the original.
2) Cutting at low speed (20-40 M/min) is easy to vibrate and the tool life is expected to be shortened.
3. Effect of feed rate: The feed rate is the key factor in determining the quality of the surface to be machined. All the way also affects the scale of the chips and the thickness of the chips during processing. In terms of the effect on the tool life, when the supply is too small, the flank wear is large, the tool life is greatly reduced, the feed is too large, the cutting temperature is increased, the flank wear is increased, but the cutting speed is higher than the cutting speed. The effect of the number is small.
4. Depth of cut (AP): refers to depth of cut, and the undisposed appearance between processing and poor is mm. This is a difference between the diameter of a piece of raw material and half the diameter of the processing.
5, feed (fn): Feed is the amount of movement of the workpiece per revolution, mm/rev.
6, cutting speed (Vc): When the workpiece in the machine torsion, the revolutionary limit of the spindle speed per minute. Rotary work, where the cutting speed is at the cutting point diameter, is called the linear speed. Generally, the linear speed is used to consider the influence of the cutting speed on machining.
In the use of radial drilling machines, there are six factors that affect the cutting results.