1, Â Â Â Â Â Â Â Â Do the following checks before driving ( 1 ) Check whether the connection of each component of the equipment is tight. Check the oil pressure, oil quantity, oil temperature and motor and bearing temperature and lubrication every 15 minutes during operation to observe whether the oil level is up to standard and whether the oil filter network is unblocked. ( 2 ) Whether the tension of each spring is appropriate or not, and the wear of the discharge funnel. ( 3 ) Whether there are residual ore and debris in the round grinding, it is strictly forbidden to start with load. 2, Â Â Â Â Â Â Â Â When starting the interlocking device, it must be operated strictly in the order of starting. First, the driving signal is issued, and then the dust removing device is started, and the signal that allows the starting device to be activated can be started. 3, Â Â Â Â Â Â Â Â The device is prohibited from swiping by hand during operation. Check the inlet and discharge ports and the rotating part, and must stop. 4, Â Â Â Â Â Â Â Â When servicing the equipment, the power must be turned off and a warning sign that prohibits closing must be attached to prevent misoperation. 5, Â Â Â Â Â Â Â Â To maintain uniformity to the ore, to prevent excessive or iron ore into the cone blocks explosives. 6, Â Â Â Â Â Â Â Â During operation, it is necessary to constantly observe whether the screws in each part are loose or not, and whether the oil pump of the oil circuit has oil leakage. 7, Â Â Â Â Â Â Â Â When parking, stop the mine first. After the mine has no mine, stop the oil and stop the oil. When the power is suddenly cut off, immediately pull down the switch and clean the residual mine. Oil Tools,Drill Collar,Slotted Screen Pipe,Erw Steel Pipe For Oil PUYANG RENHE INDUSTRY CO.,LTD , https://www.rhsuckerrod.com