Fe Alloy Powder,Stainless Powder,High Temperature Powder,Iron Base Pta Welding Powder Luoyang Golden Egret Geotools Co., Ltd , https://www.xtccarbide.com
There are single-channel, dual-channel, and three-channel full-high gates.... The installation method is the same for several channels. Xingshun An shared with you the dual channel full high gate installation steps:
First, the double channel full high gate has three support bars, two gate bars and two top boxes and two side guardrails.
Second, when the installation of the first four people put the top box up, a person to the side of the guardrail and the top box docking, when installing the top box, the top box lid and screw holes to align, use the stairs to climb to the top of the chassis All the screws are tightened. Finally, the middle lever is installed in the seat. Before installing the lever, put the movable bearing on it. The full height gate stood up.
Third, hit the screw, with 10 * 80MM or 10 * 100MM expansion screws fixed (manufacturers provide). Drill the hole and install the screws with a wrench to fix the screws.
Fourth, connected to the three-core power cord and ultra-five or over six network cable, through the power and access to the network. carry out.
Fourth, testing, credit card testing, emergency button testing. After the test is completed, it is ready to be screwed.
When installing, pay special attention to the hole position.
Drawing description
First, the full height gate when the label is shipped (Rod A and B, A to A channel, B to B channel)
Second, the full height brake fixed foot description
Second, when the power is turned off, the emergency switch of the full-high gate is opened with a key, and when the power is turned on, the key must be turned back in time to set the key out.
Fourth, the top of the full-gate channel channel hole position